Its Black Edition is always preferred for better functionality which is shown above in images. This tool is used to download, upload and format the firmware in set top boxes and satellite receivers or any other equipments. (5) It is small, compact, handy and easy to use tool. (4) It can also be connected with smartphone for upgradation and backup of flash IC data.
#Ch341a eeprom programmer upgrade#
(3) You can upgrade and backup data without removing the Flash IC from PCB plate. (2) You can also get the backup of currently available data on Flahs iCs. (1) It enable you to upgrade of various kind Of Flahs ICs used for satellite receivers, set top boxes and terrestrial receivers etc. After reading the flash IC you can press this Save Button to get the backup of data. This function is used to save or backup the currently available data on flash IC. We need not to give command multiple times. This button is used to write or program the data in flahs IC then it will automatically verify it. That is why we need to use this function. (6) Verify FunctionĪfter writing the data on the flash IC we need to check the data that it is written properly or not. Where you need to browse file to write the data on flash IC. Because function of this button is to write the data on flash IC. Program Button can also be called as Write Button. You can perform this action after erasing the data from chip. This function is used to check your chip is blank or not. It take near about 5 seconds to remove the data from flash ic. Then it will show currently available data on screen then press Erase Button to remove it. To erase the available data on the flash IC you need to first press the Read Button. This button is used to erase or format the currently available data on flash ic. If your IC is having 4 MB data then it takes around 3 minutes.Īfter that it shows the data available on this flash IC.
Initially when you open the programmer software then on screen it shows blank data like FF FF FF FF etc.īut when we press Read Button then this software started to read Flash IC Data. After this information confirmation you need go for following buttons according your use case.
#Ch341a eeprom programmer full#
So this button is used to show full information of flash IC like its Make, Memory and Device ID etc. If its reading flash IC then it will show you information of Flash IC. Because it indicates that your flash ic is connected properly or not. This is the first button which we should press after connecting this programmer.